Here are the supplies you'll need:
~ Two bags of Tubular Crin (this is a minimum for a full pair of falls)
~ Two Ponytail Holders (this can be substituted for two strips of .5 yard lace)
~ Elastic rubber bands (I prefer the clear kind)
~ Scissors
~ Measuring Tape
Step 1:
~To find out how long you want your Cyberlox, take the measuring tape and place the end, "0", where you will place your bun.
~I prefer my bun a little further back than center and close to the top.
~Remember the number where you want your Cyberlox to fall.
Step 2:
~Place the Ponytail Holder so that it's stretched slightly.
~The easiest way to do this is to use the wall hooks on a table top as shown.
Step 3:
~Take the measurement you got from the Measuring Tape and lay out your crin.
~I have preset markings on this table.
Step 4:
~Fold the crin over so that you've got the measured crin on one side of your fingers and the rest of the bag on the other side as shown.
Step 5:
~Now, cut the side of remaining crin so that it equals the measurement of the pre-measured crin.
~I cut about a half inch to an inch extra because crin has a tendency to be shorter after cutting due to the weight of the extra crin.
Step 6:
~Now, loop the crin through the Pony Tail Holder as shown.
~Make sure to get the center of the crin close to Pony Tail Holder.
Step 7:
~Use an elastic rubber band to secure the crin as shown.
Extra Tip!
~To make the ends look smooth and prevent fraying:
Step 1:
~Pinch the end of the crin
Step 2:
~Fold it back into itself so it shows as above
~This makes the ends look nicer and prevents the crin from unraveling.
END RESULT
Under Blacklight:
Crin Suppliers:
ikickshins.net
Cypherlox.com
